Control your Foil Drive Assist throttle from your paddle with our custom designed throttle

controller mount - Controller not included!

The mounts come in both left and right specifications, indicating which side of the board

your paddle blade goes into the water, not what hand you use. Generally, a natural stance

requires a “right” and a goofy stance needs a “left”.

However, the mount can be used for bottom or top hand control. If you would prefer

to use your bottom hand, the mount and therefore controller is inverted. For top hand

installation, the controller will be upright. Both installations will use the thumb for throttle

trigger control. You can see in the images Ben is using a Right controller in both positions.

Paddle shaft diameters do vary slightly between manufacturers, the most common size is

29mm so has been designed around this measurement. If you have a thinner paddle shaft,

you can use some thin foam or double sided tape to expand the diameter of your paddle

shaft, we do also include a plastic shim.

We recommend using 2 strips of electrical tape down the shaft of your paddle to protect

its surface as well as allow the mount to grip the shaft better. Carbon is a very hard

material and does not allow the mount to grip without excessive clamping pressure. With

some soft electrical tape on the paddle before mounting, the bolts only require finger

tight tension to remain in position.

Ergonomically designed paddle mounts allow for full grip of the shaft while paddling and

controlling throttle.

We recommend leaving the paddle mount slightly loose for the first few uses to allow for

on water fine tuning of the position on the paddle.